Woodstock MICRO MILL M1036 - Manual (Page 15)

-13-
M1036 Micro Mill
SE
T
U
P
Installation of the compound slide table is not necessary
when using the mill as a drill. The compound slide table
can be moved in the X and Y axis for use with milling
cutters.
To install the compound slide table, do these steps:
1. Thread the handwheel handles into the handwheels.
2. Remove the fence from the base if installed.
3. Slide the T-bolts into the T-slots and place the
compound slide table over the T-bolts, as shown in
Figure 8.
4. Measure at the front and back of the compound
slide table as shown in Figure 9 to make sure the
compound slide table is parallel to the base.
5. Place washers over the T-bolts and secure the com-
pound slide table with the hex nuts.
Compound Slide Table
Figure 8. T-bolt installation.
Figure 9. Aligning the compound slide
table.
Figure 10. Securing the vise.
To install the vise, do these steps:
1. Slide the T-nuts into the compound slide table.
2. Place the vise on the compound slide table and
loosely secure it by threading two M6-1 x 18 cap
screws with washers through the vise and into the T-
bolts, as shown in Figure 10.
3. Align the vise parallel to the compound slide table
and tighten the cap screws.
Vise