Sanyo EM-S9515W - Manual (Page 9)

9
SET UP
3"
3"
3"
OPEN
INSTALLATION
Remove all packing material and accessories. Examine the oven for any
damage such as dents or broken door. Do not install if oven is damaged.
Do not remove the light brown Mica cover that is attached inside the oven
cavity to protect the magnetron.
NOTE: This unit is not designed for 50 Hz or any circuit other than a
120-volt/ 60-Hz AC circuit. This oven is designed for countertop installation.
Countertop Installation
1. Select a level surface that
provides enough open space for
the intake and/or outlet vents.
A minimum clearance of 3 inches is
required between the oven and any
adjacent wall. One side must
be open.
• Leave a minimum clearance of
3 inches above the oven.
• Do not remove the legs from
the bottom of the oven.
• Blocking the intake and/or outlet
openings can damage the oven.
• Place the oven as far away
from radios and TV’s as possible.
Operation of microwave oven
may cause interference to your
radio or TV.
• If the cabinet is covered with a
protective film, remove the film.
2. Plug your oven into a standard
120-volt / 60-Hz household outlet.
Be sure the electrical circuit is
at least 15 amperes and that
your microwave oven is the
only appliance on the circuit.
WARNING: Do not install oven
over a range cooktop or other
heat-producing appliance.
If installed near or over a heat
source, the oven could be
damaged and the warranty
would be void.