Samson S zone - Manual (Page 6)

INPUT SECTION
1
VOLUME – Rotary control used to adjust the level of
signal source connected to channel 1.
2 ZONE 1 – When the LED Backlit switch is pressed
in, the switch lights red and the input is assigned to
ZONE 1.
3 ZONE 2 – When the LED Backlit switch is pressed in,
the switch lights green and the input is assigned to
ZONE 2.
4 STEREO/MONO switch - This switch is used to
select either stereo or mono input.
5 SCRIBE STRIP – Convenient area for marking the
input source allowing you to label the channel with
the device connected to the input.
6 ZONE 3 – When the LED Backlit switch is pressed in,
the switch lights amber and the input is assigned to
ZONE 3.
7 ZONE 4 – When the LED Backlit switch is pressed in,
the switch lights orange and the input is assigned to
ZONE 4.
8 MIC/LINE 2 – Channel 2 input with the same knob
and switch complement as Channel 1.
9 LINE 3 – Channel 3 input with the same knob and
switch complement as Channel 1.
10 LINE 4 10 10 – Channel 4 input with the same knob and
switch complement as Channel 1.
MONITOR SECTION
11 MONITOR SPEAKER – This built-in, miniature super-
speaker allows you to listen to the signal that is pres-
ent at any ZONE OUTPUT.
12 MONITOR VOLUME - This rotary control is used
to adjust the monitor level heard in the front panel
Headphone jack or SUPER SPEAKER.
Headphone jack or SUPER SPEAKER.
4
Controls and Functions
Front Panel Layout
13 ZONE SELECT switch 13 13 – This four-position switch is
used to assign any of the four Zones to play in the
MONITOR SPEAKER or HEADPHONE JACK.
14 HEADPHONE JACK 14 14 - Connect any standard stereo HEADPHONE JACK HEADPHONE JACK
headphone using a standard 1/4-inch jack to moni-
tor the ZONE OUTPUTS.
ZONE OUTPUT SECTION
15 VOLUME 15 15 – This rotary control is used to control the
overall level of OUTPUT ZONE 1.
16 HIGH – High frequency equalizer rotary control
with +/-12 dB of cut or boost at 10kHz.
17 OUTPUT METER – Six-segment LED meter display-
ing the level of the ZONE 1 OUTPUT with -20 to +14
dB indicators.
18 STEREO/MONO switch - This switch is used to
select either stereo or mono operation on the ZONE
1 OUTPUT.
19 SCRIBE STRIP 19 19 – Convenient area for marking the
ZONE OUTPUT allowing you to notate the room or
area the zone is feeding.
20 LOW– Low frequency equalizer rotary control with
+/-12 dB of cut or boost at 100Hz.
21 ZONE OUTPUT 2 – ZONE 2 OUTPUT with the same
knob and switch complement as ZONE 1 OUTPUT.
22 ZONE OUTPUT 3 22 22 – ZONE 3 OUTPUT with the same
knob and switch complement as ZONE 1 OUTPUT.
23 ZONE OUTPUT 4 23 23 – ZONE 4 OUTPUT with the same
knob and switch complement as ZONE 1 OUTPUT.
24 POWER switch 24 24 – Use this switch to power the unit
on and off.
� � � �
� � � � � �� �� ��
�� �� �� ��
�� �� �� �� �� �� �� ��