SUPER MICRO Computer SUPERSERVER 6014P-8R - Manual (Page 56)

5-22
S UPER S ERVER 6014P-8/6014P-8R/6014P-82R/6014P-82 User's Manual
Watch Dog
JWD1 controls Watch Dog, a sys-
t e m m o n i t o r t h a t t a k e s a c t i o n
w h e n a s o f t w a r e a p p l i c a t i o n
freezes the system. Jumping pins
1-2 will cause WD to reset the
system if an application is hung
up. Jumping pins 2-3 will generate
a non-maskable interrupt signal for
the application that is hung up.
S e e t h e t a b l e o n t h e r i g h t f o r
jumper settings. Watch Dog can
also be enabled via BIOS.
Note: When enabled, the user
needs to write his own application
software in order to disable the
Watch Dog Timer.
Jumper
Position
Pins 1-2
Pins 2-3
Open
Definition
WD to Reset
WD to NMI
Disabled
Watch Dog
Jumper Settings (JWD1)
Memory Speed Select
(X6DHP-8G only)
Use XJ4F1 and XJ4F2 to select the
speed of the system memory. See
the table on the right for jumper
definitions. The default setting is
closed (DDR333).
Note: if these jumpers are not set
c o r r e c t l y , y o u m a y e x p e r i e n c e
problems with your video display.
Memory Speed Select
Jumper Settings
(XJ4F1, XJ4F2)
XJ4F1
Closed
Open
XJ4F2
Closed
Open
Memory Speed
333 MHz
(DDR333)
266 MHz
(DDR266)