Sony STR-DG920 - Manual (Page 94)

94 US
For details on the Auto Calibration, see “9:
Calibrating the appropriate speaker settings
automatically (Auto Calibration)” (page 39).
Refer to “Before you perform Auto
Calibration” (page 40) before performing the
Auto Calibration.
To operate on the receiver
1 Press GUI MODE repeatedly to select “GUI
OFF”.
2 Press AMP.
Receiver operation is enabled.
3 Press MENU.
4 Press V/v repeatedly to select “
CAL>”, then press .
5 Press V/v repeatedly to select “A.CAL
START”, then press to start the
measurement.
Measurement starts in 5 seconds. A count
down is displayed.
Note
While the time is counting down, stand away
from the measurement area to avoid measurement
error.
6 Measurement starts.
The measurement process will take
approximately 30 seconds. Wait until the
measurement process completes.
To cancel Auto Calibration
The measurement will be canceled when you
do the following:
– Press ?/1, input buttons or MUTING.
– Press SPEAKERS (OFF/A/B/A+B) on the
receiver.
– Change the volume level.
– Connect the headphones.
Tips
• Operations other than turning the receiver on or off
are deactivated during Auto Calibration.
• The measurements may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
To confirm/save Auto
Calibration when GUI function
is turned off
1 Confirm the measurement result.
When the measurement ends, a beep sounds
and the measurement result appears on the
display.
2 Press V/v repeatedly to select the item, then
press .
Performing Auto Calibration
Measurement
result Display Explanation
When the
measurement
process
completes
properly COMPLETE Proceed to step 2.
When the
measurement
process fails E – xxx :
xx
See “Message list
after Auto
Calibration
measurement”
(page 43).
Item Explanation
RETRY Performs the Auto Calibration
again.
SAVE EXIT Saves the measurement results
and exits the setting process.
WARN
CHECK Displays a warning concerning
the measurement results. See
“Message list after Auto
Calibration measurement”
(page 43).
PHASE INFO. Displays the phase of each
speaker (in phase/out of phase).
See “When you select “PHASE
INFO.”” (page 95).
DIST. INFO. Displays the measurement
result for speaker distance.