Sony NT-2 - Manual (Page 11)

11
-EN
Power sources and setting the clock
4
Repeat steps 2 and 3 to set the month, date, hour, and
minute.
The display changes as
illustrated.
The time is displayed in the
24-hour system.
5
After setting the minute, press MODE.
The clock starts operating, and the current time (hour, minute,
and second) is displayed.
To set the time precisely, press MODE at the same time as a time
signal.
Hour (H) flashes.
Date (D) flashes.
Y M D
L R
Y M D
L R
H M S
L R
H S
L R
M
0
FWD
6
12
20
30
40
–dB
0
6
12
20
30
40
–dB
0
FWD
6
12
20
30
40
–dB
FWD
FWD
0
6
12
20
30
40
–dB
CLOCK
CLOCK
CLOCK
CLOCK
Minute (M) flashes.
If you make a mistake while setting
the clock
Press CLOCK SET to release the setting
mode, and start setting the clock again
from step 2. You can skip the correct
digits by pressing MODE and go on to
the digits you want to reset.
If the clock loses time
Adjust the clock again according to the
steps above.
We recommend you to adjust the clock
periodically to stamp the accurate date
and time.