Sanyo DP32746 - Manual (Page 13)

13 Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
The Component Video jacks will accept any
video content.
Switch off DTV and external equipment before
connecting cables.
(Cables are not supplied.)
Follow these steps to easily connect your STB
or DVD Player to this DTV:
1 Connect DVD Player or similar digital
equipment’s Component Video Out to the
DTV’s Video (VIDEO3) jacks.
2 Connect DVD Player or similar digital
equipment’s Audio Out to the DTV’s
VIDEO3 Audio jacks.
3 Press POWER to turn on the DTV, then
turn on external equipment.
4 Press INPUT to select Video 3 to view the
DVD program.
DVD PLAYER
(or similar digital
device such as a
Satellite Receiver.)
COMPONENT
JACKS
1
What you will need
for connections:
Component Video Cable – 1
Audio Cable – 1
DIGITAL AV CONNECTIONS
2
REMOTE CONTROL
4 3
USING COMPONENT JACKS TO CONNECT A DVD PLAYER OR
OTHER DIGITAL EQUIPMENT
■
VIDEO2 and VIDEO3 jacks have identical functions.
Compatible video devices can be connected to either set
of jacks.
■
Press the INPUT key after connecting the cables, to
select the
Video 2 or Video 3 input signal. There is NO
need to tune to a blank channel.
■
“ No Signal” will appear randomly on the screen when
no signal is detected at the VIDEO2 or VIDEO3 inputs.
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must
run All Channel Search twice before you can
select the AV inputs.
DTV BACK