StarDot Technologies netcam XL - Manual (Page 36)

Page 36 NetCam XL
Delay
The number of milliseconds to delay between image captures. For
the fastest possible frame rate, set this to 33. Viewing other video sources
during the triggered capture will affect the recording speed. Assuming no
other video sources are being viewed/uploaded, here are some example
frames rates for a single triggered video source:
33 ms = 30 Frames Per Second (Max Speed)
250 ms = 4 FPS
500 ms = 2 FPS
1000 ms = 1 FPS
Count
The number of post-buffer images to store. There is a finite amount
of memory in which to store images. Keep the total number of pre and
post-buffer medium resolution images to below 50, even less for full size
images.
UPLOAD VIA FTP
If you’d like the event-triggered image captures to be uploaded to
an FTP server, select this option. The “Upload via FTP” parameters are
independent of the regular image FTP parameters (see Chapter 3.5).
Hostname
The hostname is the name of the server where you'd like NetCam
to upload images to. It can be a machine name or an IP address. Do not
include the http:// or ftp:// header or a path.
Example: example.com or ftp.example.com
Username
This is the username or login name assigned to you by your hosting
provider.
Password
This is the password assigned to you by your hosting provider
Path
Specify the path on your FTP server where you’d like the images
stored. There is no need to specify a filename. NetCam automatically
creates sequential filenames (image0-000.jpg, image0-001.jpg, image0-
002.jpg, etc.).
Passive Mode
If NetCam is behind a proxy server, enable passive mode. If you are