Woodstock Combination Model - Manual (Page 26)

-23-
OPERATIONS
Testing
Once assembly is complete and adjustments
have been made, the machine is ready for a test
run. The purpose of a test run is to identify any
unusual noises and vibrations, as well as to con-
firm the machine is performing as intended.
1. Turn the machine on by pulling the START
paddle on the power switch. Be sure to have
your finger poised to push the paddle in if
there is a problem.
2. Once the machine is running, listen for any
unusual noises. The machine should run
smoothly with little or no vibrations.
3. If there are any unusual noises or vibrations,
shut the machine off immediately. The
machine should not be run any further until
the problems are corrected.
4. Unplug the machine and investigate the
source of the noise or vibration. Do not make
any adjustments to the machine while it is
plugged in.
Wear safety glasses dur-
ing the entire operations
process. Failure to com-
ply may result in serious
personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
!
Always wear a dust
mask when operating
the W1676. Using this
machine produces saw-
dust which may cause
allergic reactions or
respiratory problems.