Silicon Image SiliconDrive SSD-C08G(I)-3600 - Manual (Page 20)

E LECTRICAL S PECIFICATION SSD-C XXX (I)-3600 D ATA S HEET
S ILICON S YSTEMS P ROPRIETARY
This document and the information contained within it is confidential and proprietary to SiliconSystems, Inc.
All unauthorized use and/or reproduction is prohibited.
3600C-04DSR P AGE 10 F EBRUARY 2, 2009
-IORD
(PC Card memory
mode) 34 I This signal is not used in this mode.
-IORD
(PC Card I/O
mode) This is an I/O read strobe generated
by the host. This signal gates I/O data
onto the bus from the SiliconDrive CF
when the card is configured to use the
I/O interface.
-IORD
(True IDE mode) In true IDE mode, this signal has the
same function as the PC Card I/O
mode.
-IOWR
(PC Card memory
mode) 35 I This signal is not used in this mode.
-IOWR
(PC Card I/O
mode) The I/O write strobe pulse is used to
clock I/O data on the Card data bus
into the SiliconDrive CF controller
registers when the SiliconDrive CF is
configured to use the I/O interface.
The clocking occurs on the negative-
to-positive edge of the signal (the
trailing edge).
-IOWR
(True IDE mode) In true IDE mode, this signal has the
same function as the PC Card I/O
mode.
-OE
(PC Card memory
mode) 9 I This is an output enable strobe
generated by the host interface, which
is used to read:
• Data from the SiliconDrive CF in
memory mode.
• The CIS and configuration
registers.
-OE
(PC Card I/O
mode) In PC Card I/O mode, this signal is
used to read the CIS and
configuration registers.
Table 8: Signal Descriptions (Continued)
Signal Name Pin Type Description