Shindaiwa 89302 - Manual (Page 7)

7
Assembly (continued)
Cutting Attachment Shield
Insert the cutting attachment shield 1.
between the outer tube and the cutting
attachment mounting plate.
WARNING!
NEVER operate the unit
without the cutting attachment shield
installed and tightly secured!
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-head
cap screws.
NOTE:
It may be necessary to loosen the retain-
ing nut and clamp screw to adjust cutting
attachment shield mounting plate.
Fit the two spacers and the bracket 2.
over the outer tube and loosely install
the four socket-head screws.
Tighten the four socket-head cap 3.
screws to secure the cutting attachment
shield.
CAUTION!
Make sure the sub-shield is completely
hooked at the hook receiver.
Sub-Shield (when trimmer head is in use)
Attach the shield extension to the cut- 1.
ting attachment shield.
WARNING!
NEVER use this machine
without sub-shield when using a trim-
mer head.
Sub-shield Hook
Hook Receiver
Cutting Attachment Shield
Outer Tube
Socket-Head
Cap Screws
Retaining
Nut
Mounting Plate
Spacer
Spacer
Bracket
Cutting Attachment
Shield w/subshield
Attach the shield extension to the cutting
attachment shield
Cutting attachment shield assembly
NOTE:
This unit is shipped with Holder A, Holder
B, shaft bolt, and bolt guard installed.
The shaft bolt is a LEFT-HAND thread.
Remove it by turning CLOCKWISE!
With the gearcase output shaft facing 1.
up, rotate the gearshaft and Holder A
until the hole in Holder A aligns with
the matching hole in the gearcase
flange, and then lock the holder to the
gearcase by inserting the long end of
the hex wrench through both holes.
Using the combination spark plug/ 2.
screwdriver wrench, remove the shaft
bolt, bolt guard and Holder B. (The bolt
guard and shaft bolt are not used with a
trimmer head).
Install Holder B on the gearcase shaft. 3.
The splined hole on Holder B must
engage with the gearcase shaft.
Shaft Bolt
Bolt Guard
Gear Shaft
Hex Wrench
Holder B
Holder A
Hand-tighten Trimmer Head (counter-
clockwise to install)
Using the hex wrench to secure Holder 4.
A, install and hand-tighten the trimmer
head (counter-clockwise to install).
Remove the hex wrench from the 5.
gearcase and holder.
Installing a Trimmer Head
This unit is now completely
assembled and ready to use as a
trimmer.