Sanyo PLC-ET30L - Manual (Page 12)

12
!0 R/C jACK
When using the wired remote control, connect the
wired remote control to this jack with a remote
control cable (not supplied).
!2 MONITOR OUTPUT TERMINAL (ANALOG)
This terminal outputs the video signal from
computer to external video equipment (p.20).
✽ RESET button
A built-in micro processor which controls this unit
may occasionally malfunction and need to be reset.
This can be done by pressing the RESET button
with a pen, which will shut down and restart the
unit. Do not use the RESET function excessively.
Rear Terminal
!1 AUDIO MONITOR OUTPUT jACK (VARIABLE)
This jack outputs the audio signal from computer
or video equipment to external audio equipment
(pp.20–22).
!3 CONTROL PORT CONNECTOR
When controlling the projector from a computer,
connect the computer to this connector with a
control cable.
!4 INFRARED REMOTE RECEIVER (Back)
The infrared remote receiver is also located in the
front (pp.10, 16).
Part Names and Functions
!0 !1 !2 !3 !4 ✽