Sharp AF-R140DX - Manual (Page 13)

13
CLOSED OPEN
EXHAUST Lever
HOW TO OPERATE
Adjust the louvers to change the direction
of air flow for uniform and efficient cooling
of the room.
Vertical louvers
Adjusts LEFT/RIGHT air flow
If air in your room is stale, set the
EXHAUST lever to the OPEN position.
This will exhaust stale air to the outside.
The EXHAUST lever should normally
be kept in the CLOSED position during
cooling for maximum efficiency.
Horizontal louvers
Adjusts UP/DOWN air flow
ENERGY SAVER
During normal operation, the thermostat automatically controls cooling and the fan runs continu-
ously. When the ENERGY SAVER is selected, the thermostat automatically controls cooling and
the fan automatically stops when the compressor is not operating. (Fan will stop 30 seconds after
the compressor stops. After the fan stops, the fan is programmed to rotate for approx. 2 minutes
to detect room temperature. This will occur within a 20 min time span.)
2 To cancel, touch ENERGY SAVER
pad again.
• ENERGY SAVER indicator will go
off.
NOTE: ENERGY SAVER cannot be set during fan only (HIGH FAN, MED FAN, LOW FAN)
operation.
During cooling operation
1
Touch ENERGY SAVER pad.
• ENERGY SAVER indicator will light.
POWER
ON/OFF
F
hr
SELECTOR
TIMER
ON/OFF
ENERGY
SAVER
COOL / FAN
TEMP
ENERGY SAVER indicator
ENERGY SAVER pad
TO CHANGE AIR FLOW DIRECTION
EXHAUST