Snapper M26 Series - Manual (Page 15)

15 51-3845, 7/04
Install Brush Head
1. Use tractor lift lever to lower hitch.
2. Position tractor in line with brush head.
3. Drive forward until hitch touches brush head, lift
hitch to engage implement.
4. Stop tractor engine, get off tractor, ensure pins
snap and engage into hitch. (figure 1.)
5. Connect drive line.
6. Connect cylinder to hitch and hydraulic lines to
tractor.
7. Place storage stands in up position.
Figure 1.
Brush head not shown
OPERATION SECTION
INSTALLATION
Closed
(In)