beautypg.com

Sanyo EM-S8597W User Manual

Page 10

background image

9

1. Touch DEFROST BY WEIGHT pad.

2. Enter

weight.

3. Touch START/STOP pad.

NOTE:

You may need to turn food over at the

middle of cooking time to obtain uniform

cooking.

·Weight must be in pounds and ounces.

Ounce weights less than 10 must be

preceded by a 0. If label gives weight in

pounds only, change the fraction of a pound

to ounces using the chart on this page.

·Maximum weight for defrosting is 2700g.

·Turn food over when oven beep twice.

Touch START/STOP pad to resume

defrosting.

·After total defrosting time, “END” appears

in display.

Touch RESET or open oven door to clear

END before starting another cooking

function.

SETTING “SPEED DEFROST”

1. Touch SPEED DEFROST pad.

2.

Enter desired defrosting time by

touching correct number pads. Digital

timer sets minutes and seconds from

left to right so a single digit can be set

(5 for 5 seconds ) or up to 4 digits

(2405 for 24 minutes 5 seconds).

3. Touch START/STOP pad.

NOTE:

·In the middle of cooking time the system

will sound to remind you to turn over the

food and pause until you depress the

button start to enter into the next

defrosting stage, and the system

resume

After time has elapsed “END” appears

in display. Touch RESET pad or open

door to clear END before starting

another cooking function.

SETTING “SAFETY LOCK”

The safety lock prevents unsupervised

operation by little children.

To set, press and hold RESET pad for 3

seconds, LOCK indicator lights.

To cancel, press and hold RESET pad for

3 seconds, LOCK indicator goes off.

SETTING “QUICK ON”

With each touch of the QUICK ON pad you

can program the oven for:

30 sec. ………TOUCH ONCE

1 min……….TOUCH TWICE

2 min……….TOUCH 3 TIMES

3 min……….TOUCH

4

TIMES

4 min……….TOUCH

5

TIMES

5 min……….TOUCH

6

TIMES

6 min……….TOUCH

7

TIMES

7 min……….TOUCH

8

TIMES

8 min……….TOUCH

9

TIMES

9 min……….TOUCH

10

TIMES

10 min……….TOUCH 11 TIMES

The oven will operate at 100% power

and

without touching START.