Stewart Filmscreen Corp B - Manual (Page 10)

The motor requires standard 120V 60 Hz input (unless an alternate voltage
has been specified). All connections are made to the electrical box on the
side of the Luxus unit (audience left).
In addition to the standard high-voltage 3-position switch, there are optional
switch controls available for the Luxus Electriscreen. Follow the installation
procedure for the type of switch control you will install.
General suggestions for wiring:
‹ Soldering is recommended.
‹ The use of wire nuts is acceptable.
‹ On models not provided with armored whip, a romex connector
should be installed in the appropriate electrical KO (Knock Out).
To open the electrical box, remove the two socket cap screws that attach
the end plate to the unit’s case.
Refer to Figure 6 for an illustration of the electrical connection box on the
side of the screen unit.
The standard electrical hook up is through the large black electrical
grommet located on the back side of the case adjacent to the end plate.
An optional electrical knockout has been provided should the particular
installation require that the electrical connection be made through the side
end plate.
8 Stewart Filmscreen Corporation
S
TEP
2. E
LECTRICAL
H
OOK
-
UP
Caution
Professional techniques need to be adhered to when making
any electrical connection. A qualified electrician should
perform these procedures.
Be sure to follow all standard safety procedures for installing
electrical devices.
Do not disassemble or alter the configuration of the motor or
the unit's electrical connections. This may cause injury to you
or damage to the product.
The electrical connection should be made only to the type of
power source indicated on the marking label.
Figure 6: Electrical connection
box
Electrical Connection
Box (behind end plate)
Electrical
Knockout
(optional)
Socket
Cap
Screws