Schutt Sports C2000 - Manual (Page 14)

C1000 & C2000 Assembly Instructions
14 www.schuttsports.com 800-426-9784
Base Assembly - C2000
continued...
Step 1: Push two brackets (1) down to
raise brake feet and lower wheels.
Step 2: Remove four countersunk
screws from lower padding. (Lower
padding has six sides.)
Step 3: Attach padding (2) to underside
of brackets using screws.
NOTE: Operate brake feet and wheels
as follows:
• To lower brake feet and raise wheels,
push up on padding until red lever
latches.
• To raise brake feet and lower wheels,
release red lever; pull out on
padding, and rotate padding down
completely.
Step 4: Remove strap that holds main
post in place. Do not remove strap that
holds slider post in place.
CAUTION: Pinch points can crush
fingers. To prevent serious injury,
avoid all pinch points by grabbing
handle on main post back side with
both hands when lifting post into
place.
Step 5: Grab handle on main post (3)
back side, and lift post until it snaps
into place. Tighten 1/2" nut (4) between
top of main post (3) and mast (5) to
lock assembly.
1
3 4 5
2