Sirius Satellite Radio INV2 - Manual (Page 25)

[
Installation
] 25
Follow these detailed cable installation instructions:
Feed the antenna cable underneath the rubber weather stripping of the rear tail-
gate window/door and route the cable along the rear hatch. Lift the weather strip-
ping from the opening and tuck the cable inside it, then replace the weather strip-
ping. Pull the cable out from weather stripping and route it into the cabin under the
interior trim. Avoid hinges or gears that could crimp or cut the cable.
Route the cable through the SUV’s main cabin area under the interior trim, towards
the front of the vehicle. Use a plastic putty knife to lift the plastic trim just enough
to tuck the cable under underneath. Avoid side airbag locations on back pillars and
above the doors. (Airbag locations are marked with “SRS” logos.) Be careful not
to crimp or cut the cable.
Bring the cable out from the trim near the firewall and route it under the carpet
toward the dashboard or console. Coil any excess cable in a hidden location, such
as under the carpet, keeping it away from any vehicle pedals or controls. Secure
the excess cable with wire ties.
Bring the end of the cable out at the SIRIUS Vehicle Dock location. Leave yourself
enough cable so you can easily connect it to the antenna connector on the Vehicle
Dock. 1.
2.
3.
4.