Configuration overview – SpectraLink 6020 User Manual
Page 6
SpectraLink Corporation
Configuration and Administration
Link 6020 Wireless Telephone
2. Configuration Overview
Configuration of the Link 6020 handset requires several preliminary steps. The MCU
must be programmed for system feature activation as detailed in Link 150 M3
MCU: Installation and Operation or Link 3000 MCU: Operator’s Console, depending
on which type of system is installed in the facility.
The handsets are shipped from the factory with correct software code. If updates are
available, they may be downloaded from the SpectraLink website
information about updates and available downloads.
Code updates are loaded into the handset through the Dual Charger. This device has
a USB port beside the power jack to connect it with a PC. The Handset
Administration Tool is a software utility that is installed on the PC and enables the
software downloads and handset configuration. This utility may be downloaded from
the SpectraLink website. It is also provided on the SpectraLink Installation Manuals
CD.
These steps summarize the sequence for configuring handsets on a new Link WTS.
1. Configure the MCU for feature access per above references.
2. Download any available Link 6020 Wireless Telephone software updates to a PC
running Windows 2000 or Windows XP with a USB port.
3. Download the USB driver and the Handset Administration Tool.
4. Set up the Dual Charger for the Link 6020 Wireless Telephone and place the
handset in the Charger.
5. Install the USB driver software and the Handset Administration Tool software.
6. Use the
Firmware
tab of the Handset Administration Tool to download the
updated code to the handset.
7. Remove the handset from the Dual Charger and cycle the power for the settings
to take effect.
8. Record the feature settings for end users via the template provided for this
purpose.
The following sections describe these steps in detail.
PN: 72-1204-00-B.doc
Page 6