Soho RAID SR2000 - Manual (Page 20)

While data is in the HDD on the upper deck of the SR2000,
start up the computer. The computer system will
automatically check the status of the HDD on the upper
deck of the SR2000. In case of failure, the buzzer will
sound and the LCD will show the following:
Pri HDD Fail
Sec HDD OK
1. Set up a new HDD on the lower deck of the SR2000. If
the HDD is properly set up, the LCD will show the
following:
Pri HDD OK
Sec HDD OK
2. A few seconds later, the LCD will show:
The data in the lower deck’s HDD will be rebuilt in the
upper deck’s HDD.
Rebuilding …
Sec Pri XXX%
XXX%: Percentage completed, ranging from 0~100.
3. When the rebuild function is completed, the LCD will
show:
Pri HDD OK
Sec HDD OK
SOHO RAID 19