Sony Ericsson BDV-E300 - Manual (Page 17)

17 GB
Ge
tting Star
te
d
Caution
• Contact a screw shop or installer regarding the wall material or screws to be used.
• Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach
the screws securely to a beam and fasten them to the wall. Install the speakers on a vertical and flat wall where
reinforcement is applied.
• Sony is not responsible for accidents or damage caused by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
Before installing the front and surround speakers of BDV-E801 on a wall, you need to disassemble the
speakers. You can install the upper part of a speaker on a wall.
To disassemble the speaker
(Front and surround speakers of BDV-E801 only)
1
Disconnect the speaker cords from the speaker.
2
Remove the screw (pre-installed) at the rear of the speaker.
This screw is used when reassembling the speaker. Be sure not to lose the screw.
Installing the speakers on a wall
Rear of the speaker
Rear of the speaker
Screw