Sanyo PLV75L/PLV-80L - Manual (Page 54)

54
APPENDIX
• • • on • • • dim • • • off • • • flashing
✽ When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow,
replace the projection lamp with a new one promptly. Reset the Lamp Replace Counter after replacement of the lamp.
The projector is being cooled down. It cannot be turned on until
the READY indicator lights green.
Projector Condition
LAMP
REPLACE
yellow
Indicators
READY
green
LAMP
red
WARNING
TEMP.
red
The projector detects an abnormal condition and cannot be
turned on. Unplug the AC Power Cord and plug it again to turn
on the projector. If the projector is turned off again, disconnect
the AC Power Cord and contact the dealer or the service center
for service and checkup. Do not leave the projector on. It may
cause electric shock or a fire hazard.
The projector is in the Power management mode.
✽
✽
✽
The temperature inside the projector is abnormally high. The pro-
jector cannot be turned on. When the projector is cooled down
enough and the temperature returns to normal, the READY indi-
cator lights green and the projector can be turned on.
✽
The temperature inside the projector is abnormally high.
The lamp cannot light up. (The projector is preparing for stand-
by or the projection lamp is being cooled down. The projector
cannot be turned on until cooling is completed.)
The lamp cannot light up. (The lamp has been cooled down
enough and the projector is in stand-by mode and ready to be
turned on with the POWER ON-OFF button.)
✽
The life of the projection lamp draws to an end.
Replace the lamp and then reset the Lamp time. The indicator
will turn off.