Samson POWER AMPLIFERS PG3800 - Manual (Page 14)

10
Specifications
POWER SPECIFICATIONS PG-2200 PG-3800
Stereo Mode (Both channels driven) 20Hz~20KHz 8 Ohms 2 x 280W 2 x 560W
4 Ohms 2 x 500W 2 x 900W
2 Ohms 2 x 1000W 2 x 1800W
Bridge Mono Mode 20Hz~20kHz 8 Ohms 1000W 1800W
4 Ohms 2200W 3800W
ELECTRICAL SPECIFICATIONS
INPUT SENSITIVITY 1.22 V(+4 dBu) 1.15 V(+3.4 dBu)
INPUT IMPEDANCE 10K ohms Unbalanced, 20K ohms Balanced
FREQUENCY RESPONSE
(at 10dB below rated output power) 25 Hz~25 kHz +0/-1 dB -3 dB points: 5 Hz~50 kHz
VOLTAGE GAIN 32dB 34dB
DISTORTION(SMPTE IM) <0.03% <0.03%
S/N ratio 100dB 100dB
GENERAL SPECIFICATIONS
PROTECTION Full short circuit,open circuit,thermal,ultrasonic, and RF protection
stable into reactive or mismatched loads, turn ON/OFF, muting
CONTROLS Front:AC switch,Input level control for each channel. Rear: mode/
stereo/ parallel/ bridged selector; LP 30Hz filter selector,LIMITER ON/
OFF selector.
INDICATORS SIGNAL: 2 green LED;CLIP: 2 red LED; POWER: 1 Blue LED;
PROTECTION 1 red LED
CONNECTORS INPUT : Active balanced XLR and 1/4"(6.3 mm)TRS
OUTPUT: "Touch-proof" binding posts and Speakon jacks.
POWER SUPPLY Available for 110-120 V or 220~240 V AC, 50/60 Hz
DIMENSIONS 19"(W)x 15.7"(D) x3.5"(H
483(W)x 400(D) x88.8(H)mm
WEIGHT
PG2200 32.50lbs. (14.74kg)
PG3800 45.2 lbs. (20.55kg)