Sharp UX-P410 - Manual (Page 79)

Messages and Signals
77
9. T
roub
le
-
s
hooti
n
g
INCORRECT FILM/
CHECK FILM The wrong type of imaging film is loaded in the
machine. Printing is not possible. The machine can
only print when SHARP UX-9CR imaging film is
loaded.
LINE ERROR Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see
Line Error on page 71.
MEMORY IS FULL/
SEE MANUAL
(alternating messages) The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been received
to memory because printing is not possible (an
additional message will indicate the problem), resolve
the problem so that printing can continue (see
Substitute Reception to Memory on page 48). If you
are attempting to transmit from memory, see
If the
memory becomes full on page 39. If you are copying,
see
If MEMORY IS FULL appears on page 49.
MEMORY PRINTING The fax is preparing to or printing out a document
from memory.
NEAR END OF FILM/
USE SHARP SUPPLY This message appears 3 m from the end of the
imaging film (approximately 10 pages can still be
printed), and alerts you that you will soon need to
replace the film.
NO DATA This appears if you attempt to search for an auto-dial
number when none have been stored.
OFF HOOK This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.
ON HOOK DIAL
The key has been pressed and the fax machine
is waiting for you to dial.
OVER HEAT The print head has overheated. Operation can be
continued after it cools. If overheating frequently
occurs, try changing the print contrast setting to
LIGHT (see page 16).