Smeg STL 60 - Manual (Page 9)

GB 7
PROGRAMME SELECTION
Preparation of wash cycle
1. Load the machine, close the drum flaps and check that they are properly locked.
2. Add detergents and additives into the dispenser to no more than the “MAX” level mark. Please refer
to “Detergents and additives”.
3. Turn the programme selector knob to the desired programme.
4. Turn the temperature selector knob (if available) to the desired temperature.
5. Turn the spin speed selector knob (if available) to the desired spin speed. If the spin speed “0” is
selected, the final spin is cancelled, but not intermediate spins. The programme ends with a drain cycle.
6. Select the desired options as described in the Programme Chart.
Programme start
Switch on the washing machine- the indicator lights up.
Note: If there is a power interruption or if the washing machine is disconnected during the cycle, the
programme will run again from the point where it was interrupted.
End of wash cycle
• The programme selector knob is in the Stop position.
1. Switch off the washing machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5. Open the lid and the drum flaps and unload the machine.
Change the programme during the wash cycle
1. Switch off the washing machine.
2. Select the new programme.
3. Start the programme by switching on the machine.
Pause/Interrupt a programme
If for any reason you wish to interrupt the programme for a certain time and continue it later:
1. Switch off the machine.
2. After the desired pause turn on the machine again.
Cancel programme
1. Switch off the washing machine.
2. Set the programme selector to “Drain”.
3. Switch on the machine again to start the “Drain” programme.
IFU_Alpha_Sc1-mech_GB.fm Page 7 Wednesday, March 30, 2005 6:52 PM
Black process 45.0° 100.0 LPI