Silex technology SX-3700WB - Manual (Page 5)

2-5
Users Manual SX2
PRICOM SX-3700WB
< Put into infrastructure mode >
1. Please verify that AC adapter is connected and that this product has started normally.
2. Push and hold the push switch down. Continue to hold down the push switch for about 5 seconds. The lights
will blink and then the infrastructure LED will light. It is now in infrastructure mode.
- Do not turn off the printer until the printing of self-test/configuration settings has finished.
- The printer must have and internal font for the self-test/configuration settings to print.
< Self diagnostic/ Configuration Printing >
1. Verify that AC adapter is connected to this product.
2. Verify that the printer is connected and ready to print.
3. Verify that the printer is power on.
4. While holding the push switch, plug in the power supply. Status LED (Orange), Link LED (Green), InfraLED
(Green) is bringing.
5. Hold the push switch (for about 30 seconds). The self test and configuration will then begin.
- When using Infrastructure during the initial setup, disable WEP on the access point.
- If a mistake is made during the configuration, restore factory default and try again.
Push Switch
TIP
TIP