Sharp AR-156 - Manual (Page 15)

13
2
Making copies
NORMAL COPYING
Turn the power switch on.
The ready (
) indicator will light up.
● The copier will enter a power save mode once the set time has elapsed without
any copier operation after the last copy of a run is made or power is turned
on.
The settings of the power save modes can be modified. See page 21, USER
PROGRAMS.
● The copier will return to the initial settings a preset amount of time after the
last copy is made. The preset amount of time (auto clear time) can be changed.
See page 21, USER PROGRAMS.
Place the original(s) face up in the document feeder tray or face down on the original
table.
A. When using the RSPF:
(1) Make sure that no original is left on the original table.
(2) Adjust the original guides to the size of originals.
(3) Set the originals face up in the document feeder tray.
● Before feeding originals in the document feeder tray, be sure to remove any
staples or paper clips from them.
● Before placing curled or wavy originals into the document feeding tray, be
sure to flatten them. If not, original misfeeds may result.
● The RSPF ( ) indicator on the operation panel will light up. If this indicator
does not light up, the originals are not properly set or the RSPF is not properly
closed.
● Badly damaged originals may misfeed in the RSPF. It is recommended that
such originals be copied from the original table.
● Special originals such as transparency film should not be fed through the
RSPF, but should be placed directly on the original table.
● Image loss (max. 5/32" (4mm)) can occur at the leading and trailing edges of
the copies. Also image loss (max. 11/64" (4.5mm) in total) can occur along
the other edges of the copies. It can be 15/64" (6mm) (max.) at the trailing
edge of the second copy of two-sided copying.