SIGMA SD9 - Manual (Page 21)

LOADING THE BATTERIES
CR-V3
AA Type
2
Insert the batteries as indicated on the battery compartment.
3
Insert the battery case into the camera; turn the battery latch to the opposite
position to lock.
n AA Type Batteries that can be used with SD9 Camera; Alkaline Dry Cell Batteries,
Ni-Mh “Nickel-Metal Hydride”, Nickel Zinc Primary Batteries.
n This camera cannot be used for battery charging. Use only the recommended
chargers of the battery makers, when you use Ni-Mh “Nickel-Metal Hydride”
Batteries.
WARNING!!
·
Always use same battery type and do not mix battery types. Avoid using
following battery combinations.
CR-3V and “AA” type battery combination.
Alkaline Dry Cell Battery and Ni-Mh, and other battery type combinations.
Using the same type but different brands.
Do not mix the old batteries with new ones, replace them at the same time.
·
While CF Card busy light is on, please do not remove the batteries. Doing so can
result data loss. Moreover, Camera, CF card and Microdrive may be damaged.
TO REMOVE THE BATTERIES
20
When you remove the batteries from the battery
case, please remove, as shown in the illustration.
Pulling up the lever, facilities removal.