Sony CC-222 - Manual (Page 8)

1 – Introduction—Finalizing
8
TASCAM CC-222 Owner’s Manual
For the automatic tape selection function to work
properly, metal and high position (cobalt) tapes must
have the appropriate identification holes. Note that Type I (normal), Type II (high-position/
chrome) and Type IV (metal) tapes can be played
back. Recording is possible with Type I (normal) and
Type II (high-position/chrome) tapes.
About CD-R and CD-RW discs
The CC-222 uses CD-R and CD-RW media, and can
also use CD-R and CD-RW Digital Audio media.
In this manual, when we refer to “CD-R” and CD-
RW” discs, we always include “CD-R Digital Audio”
and “CD-RW Digital Audio”, even when this is not
explicitly stated.
CD-R discs can be recorded once only. Once they
have been used for recording, they cannot be erased
or re-recorded. However, if space is available on the
disc, additional material can be recorded. The pack-
aging of CD-R discs will include one of the follow-
ing logos:
By contrast, a CD-RW disc can be used in much the
same way as a CD-R disc, but the last track or tracks
recorded can be erased before the disc has been
“finalized”, and the space on the disc can be re- used
for other recordings. The packaging of CD-RW discs
will include one of the following logos:
However, you should note that an audio CD created
using a CD-RW disc may not play back satisfactorily
on every audio CD player. It will, naturally, be play-
able on the CC-222. This is in no way a limitation of
the CC-222 itself, but of the difference between the
different types of media and the methods used to read
them.
CD-R discs created on the CC-222, by contrast, may
be played satisfactorily on the majority of audio CD
players.
Finalizing
Although audio data may be written on a CD-R or
CD-RW disc, a standard CD player will not be able
to read the data (i.e. play back the audio) until a final
table of contents (TOC) has been written at the start
of the disc.
The process of writing this table of contents is known
as “finalizing”. Once this has been done, no further
data can be written to the disk. See “Finalizing” on
page 34 for details.
In the case of a CD-RW disc which has been final-
ized, the whole of the disc may be erased, or the disc
may be “refreshed”, and the disc re-used.
In addition, a CD-RW disc that has been finalized
may be “unfinalized”, i.e. the TOC is removed. This
allows further tracks to be recorded to the disc, pro-
vided that there is space on the disc.
“Recordable” discs
In this manual, we use the term “recordable” disc to
describe a CD-R or CD-RW disc that has not been finalized, i.e. further recording is possible on the
disc.