Sanyo DS32920 - Manual (Page 4)

BASIC SET-UP AND CONNECTIONS
4
CATV FRANCHISE NOTE:
Cable companies, like public
utilities, are franchised by
local government authorities.
To receive cable programs,
even with equipment which
is capable of receiving cable
channels, the consumer
must subscribe to the cable
company’s service.
QuickTips
■ The TV will automati-
cally select the correct
Antenna mode for the
type of RF signal you
connect.
■ TV will switch off
automatically after 15
minutes if there is no
signal reception (cable
out or station not
broadcasting).
Exception—When the
Video mode is selected,
the TV will not automati-
cally switch off when
signal reception has
stopped for 15 minutes.
■ If you move the TV to a
new location, press the
RESET key twice after
connecting the signal
and turning on the TV.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
IN FROM
SAT.
CATV IN
OUT TO TV S-VIDEO
CH3
CH4
L- -R AUDIO VIDEO
L- -R AUDIO VIDEO
S-VIDEO
VIDEO AUDIO INPUT
Y
P b
P r
AV2 AV1 COMPONENT
R R R R
L L L L
(MONO) (MONO)
UHF/VHF/CATV
75 Ω
AUDIO
OUTPUT
VIDEO
AUDIO AUDIO
FROM ANT.
OUT TO TV
IN
OUT
CONNECTING CABLE SERVICE, RF ANTENNA, OR SATELLITE DISH
RECEIVER TO TV
❶
❶
❶
Cable Service
RF Antenna Satellite Receiver
TV Back
POSITIONING THE TV
Do not position the TV in a confined
area. Allow space for normal air
circulation around electronic parts.
Audio / Video Input Jacks (AV1 / AV2)
Connect video equipment here (see
pages 5 ~ 6).
Note: S-Video connections override the
AV1 and AV2 video connections.
S-Video Input Terminal
To enhance video detail use the S-Video AV1
and AV2 jacks instead of the Video jacks, if
available on your external equipment.
(S-Video connections will override con-
nections to the AV input jacks.) (See page 5.)
Audio Output Jacks
Connect external audio equipment here.
(See page 6.)
INITIAL SET-UP
1. Install batteries in remote control, see page 7.
2. Connect signal, see below.
3. Plug in AC power cord.
4. Press POWER key to turn on TV.
5. Follow on-screen instructions.
480i Component Video In Jacks
(Component 3, Y, Pb, Pr)
Connect digital video equipment here. (See
page 6.)
VCR Back
Note: If you do not have a VCR
connect signal directly to TV 75
ohm jack.