Sony CS SLV-998HF MX - Manual (Page 10)

Step 3: Hookups (continued)
C Use this hookup if your TV has the S-Link™ function
Note
* To play a tape in stereo, you must use the A / V connection.
A / V hookup: VCR setup
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select Set Auto ANT SEL to
ADVANCED OPTIONS. OFF and press OK.
MENU ADVANCED OPTIONS page 1
TIMER SET / CHECK
TUNER PRESET AUTO ANT SEL ON OFF
CLOCK SET AUTO STEREO ON OFF
LANGUAGE AUDIO MIX ON OFF
SET VCR Plus+ CHANNELS TUNER AUDIO MAIN SAP
CABLE BOX CONTROLS SHARPNESS L H
ADVANCED OPTIONS
Use to select an Use to select an
item, then push OK item, then push
Caution
Connections between the VCR's VHF / UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
10 Getting started
VCR
TV
Stereo receiver
Audio/video cable (supplied) Audio cable (not supplied)