beautypg.com

Getting started, Preparing the rotary commander, Resetting the unit – Sony XR-7850 User Manual

Page 4: Detaching the front panel

background image

4

EN

Attaching the front panel

Attach part A of the front panel to part B of
the unit as illustrated and push until it clicks.

Notes

Make sure the front panel is the right way up when

attaching it to the unit as it cannot be attached upside
down.

Do not press the front panel hard against the unit when

attaching it to the unit. It can easily be attached by
pressing it lightly against the unit.

When you carry the front panel with you, put it in the

supplied front panel case.

Do not press hard or put excessive pressure to the display

windows of the front panel.

Do not expose the front panel to direct sunlight, heat

sources such as hot air ducts or leave it in a humid place.
Never leave it on the dashboard etc. of a car parked in
direct sunlight where there may be a considerable rise in
temperature inside the car.

Caution alarm

If you turn the ignition key to the OFF position
without removing the front panel, the caution
alarm will beep for a few seconds (only when
the POWER SELECT switch is set to the A
position). If you connect an optional power
amplifier to the LINE OUT and do not use the
built-in amplifier, the beep tone will be
disabled.

Preparing the rotary
commander

When you mount the rotary commander,
attach the label in the illustration below.

Getting Started

Resetting the unit

Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the reset button with a pointed object,
such as a ball-point pen.

Note
Pressing the reset button will erase all the memorized
program and memory functions.

Detaching the front panel

The front panel of this unit can be detached to
prevent the unit from being stolen.

1

Press (OFF).

2

Press (RELEASE) to detach the front
panel then gently pull it out.

Notes
• Be sure not to drop the panel when detaching it from the

unit.

• If you press (RELEASE) to detach the panel while the

unit is still turned on, the power will automatically turn
off to protect the speakers from being damaged.

B

A

Reset button

(RELEASE)

SEL

DSPL

MODE

SEL

DSPL

MODE