SPT SP-3015 - Manual (Page 4)

Storage
When planning not to use unit for a period of time, clean unit and allow unit to
dry completely. Place unit back in original box or cover with cloth/bag and store
in a cool, dry place.
Note:
•
When dumping water, best to remove lid. Never
hold the unit by the open lid.
Dump water through the rear corners, so not to wet
the control panel.
Replacing Worn Parts
The rubber gasket on the inner lid will wear over time and will need to be
replaced periodically. Contact Sunpentown (www.spt-usa.com / 909-468-5288)
to purchase replacement gaskets or for instructions to send in for repair.
Instructions on replacing the gasket:
1. Remove lid.
2. Loosen the 3 screws and remove inner lid. Do not lose the screws.
3. Remove old rubber gasket.
4. Insert new gasket according to image.
5. Replace inner lid and tighten screws.
Troubleshooting
PROBLEM POSSIBLE CAUSE
No power Loose power connection.
Will not switch to
boil / reboil
Water level is too low.
Loose power connection.
Unit just finished boiling and air bubbles are
trapped inside. Wait a few minutes or open
lid ajar to release air.
The interior is dirty and needs cleaning.
Cannot dispense water
or not dispensing
smoothly
Water level is low.
Water is flowing out
from unit
Water is filled over the FULL line.
White residues in
water These are mineral deposits. Clean the interior
with Citric Acid.
Boiling sound is
excessively loud
Interior is dirty, clean with Citric Acid.
Specifications
MODEL SP-3015 SP-3815 SP-3017
Capacity 3.0L 3.8L 3.0L
Input power 120V / 60Hz
Power consumption Heating (boiling) 700W / Keep warm 35W
Cord length 4.9 ft.
Unit may not function properly if used in high elevation or in very cold or hot conditions.
In such conditions, unit may keep boiling or not reach boiling point.
Screw
Rubber Gasket
Inner Lid
Lid
7 6