Smeg PL19K User Manual
Page 8
POWER SWITCH-ON
T
YPE
"A"
T
YPE
"B"
T
YPE
"A" Turn the ON/OFF switch (2) to the letter I.
T
YPE
"B" Press the ON/OFF key (3).
The ON light (4) illuminates.
STARTING THE DISHWASHER
After correctly carrying out all the preceding operations, to start the dishwasher simply press the
START/STOP (5) button for a few seconds, until the start cycle acoustic device sounds. The
INFORMATION DISPLAY (8) will show the duration of the program in minutes. The duration time is
only approximate, because it depends on the washing conditions (quantity of dishes, water
temperature, etc.), and is also continually updated as the washing program progresses.
If it is necessary to open dishwasher door during the washing cycle, there will be a
1-minute delay before the program can be resumed. After correctly closing the door,
press the START/STOP (5) button again. This operation may negatively affective the
progress of the washing cycle.
END OF CYCLE
The end of the washing cycle is signalled by a brief sounding of an acoustic device and by the
blinking of the selected program on the INFORMATION DISPLAY (8). Before setting a new washing
program, the door must first be opened, then reclosed, or the START/STOP (5) button pressed to
“reset” the display and stop the flashing.
TABLE FOR CERTIFICATION BODIES
Reference standard
EN 50242
Reference program
(*) Selector on P6 + ECO DRYING
Load
12 place-settings
Type of detergent
B
Amount of detergent
30 g
Rinse aid setting
Depending on the model 3/4 or 4/6
EN 50242 STANDARD LOADS
LOWER BASKET
UPPER BASKET
Depending on models, the cutlery basket may have removable grilles in which the cutlery
can be inserted to keep the items far enough apart and allow optimal water passage.