Samsung 21K10 - Manual (Page 22)

22
ENG
The “S.MODE I-II” button displays/controls the processing and
output of the audio signal. When power is switched ON, the mode
is automatically preset to either “Dual-I” or “STEREO”, depending
on the current transmission.
Selecting the Sound Mode (depending on the model)
➣
◆ If the receiving conditions deteriorate, listening will be
easier if the mode is set to the “MONO” position using
the S.MODE I-II button.
◆ If the stereo signal is weak (or if intermittent Stereo-Mono)
and automatic switching occurs, then switch to the
“MONO” mode.
◆ When receiving mono sound in the AV mode, connect to
the “L” input jack on the panels. If the mono sound
comes out only from the left speaker, then press the
S.MODE I-II button.
Switching the Sound Off Temporarily
You can switch the sound off temporarily, for example you may
wish to answer the telephone.
1 Press the MUTE button.
Result: The sound is switched off and “ ” is displayed.
2 When you wish to turn the sound back on at the same volume as
before, press the MUTE
button again (or either of the volume
buttons).
Type of broadcast
Regular broadcast
(Standard audio)
Regular +
NICAM Mono
NICAM Stereo
NICAM Dual-I/II
Regular broadcast
(Standard audio)
Bilingual or Dual-I/II
Stereo
On-screen indication
MONO (Normal use)
MONO
↔
MONO
NICAM (Normal)
STEREO
↔
MONO
NICAM (Normal)
MONO (Normal use)
Dual-I
↔
Dual-II
STEREO
↔
MONO
(Forced Mono)
Dual-I
→
Dual-II
→
MONO
NICAM NICAM (Normal)
NICAM
Stereo
A2
Stereo
→ →
KS1_01818B_02_ENG_UMG 11/18/03 10:09 AM Page 22