Shoprider ISO9001 - Manual (Page 19)

~18~
GMP
ISO9001
ISO14001
ISO13485
CERTIFIED
Charging Port (8) for Off-Board Charger
Only plug into this port with the qualified charger certified by the original
manufacturer of the Powerchair. This port should not be used as a power supply
for any other electrical devices. The behavior against the two statements as
above will void the warranty of the Powerchair.
GETTING READY TO DRIVE
STEP 1 Depress the On / Off Button, then the VSI will turn on after the Battery
Gauge blinking about a second.
STEP 2 Depress the Speed Increase / Decrease Button to set up a suitable level
that you can maneuver the Powerchair easily.
NOTE! The Powerchair will not move and the Battery Gauge will blink if you
push the joystick before or just after you turn the VSI on. To restore the
normal operating status, you have to release the joystick immediately back
to its center position. If you do not release the joystick in five seconds, the
Battery Gauge will flash rapidly and the Powerchair won’t move unless you
turn off and on the VSI again.
STEP 3 Push the joystick to control the speed and direction of the Powerchair.
NOTE! Choose an area with plenty of space to drive the Powerchair. Select
the low level of the maximum speed setting until you are familiar with the
controls. In a short time you will be in total control and can then increase
the speed in steps.
STEP 4 Let go the joystick whenever you desire to stop the Powerchair.
ENGAGED / DISENGAGED MODE
In the event of a fault or battery failure, the electromagnetic brakes can be
disengaged allowing the Powerchair to be pushed. The levers should be switched
to the freewheel position according to the indication labels of Fig.5, Fig.6, Fig.7
and Fig.8 to set the Powerchair to the Engaged / Disengaged Mode.
NOTE! Do not use or sit on the Powerchair when either of the brakes is
disengaged, or the VSI will not operate normally.
OPERATION INSTRUCTIONS