Southbend Swivel Mast Bandsaw sb1018 - Manual (Page 14)

-12-
For Machines Mfg. Since 8/09 Model SB1018 P R E P A R A T I O N
The items listed below are optional components
and are not required for bandsaw operations.
Their installation and use is covered in
Operation, beginning on Page 20.
Description Qty
P. Work Stop Assembly ......................................1
Q. Chip Deflector ................................................1
Figure 7. Optional components.
Q
P
Figure 6. Additional stand components.
O
N
M
D
L
Not Shown Qty
• Hex Wrench 4mm ..........................................1
• Hex Bolt M8-1.25 x 15 .................................12
• Hex Nut M8-1.25 ..........................................18
• Flat Washer 8mm ........................................30
• Flat Head Screws M8-1.25 x 15 ....................2
• Hex Bolt M12-1.75 x 25 ................................4
• Flat Washer 12mm ........................................4
• Hex Bolt M8-1.25 x 40 ...................................4
• Knob M6-1 x 15 ..............................................1
• Cotter Pins .....................................................2
Figure 5. Stand components.
K
I
J
Description (Figure 5) Qty
I. Chip Tray ........................................................1
J. Rear Panel ......................................................1
K. Front Panel .....................................................1
Description (Figure 6) Qty
L. Left Panel .......................................................1
M. Right Panel .....................................................1
N. Bottom Shelf ...................................................1
O. Shelf ................................................................1