SMSC USB2503A - Manual (Page 18)

Integrated USB 2.0 Compatible 3-Port Hub
Datasheet
Revision 2.3 (08-27-07) 18 SMSC USB2503/USB2503A
DATASHEET
5.2.1.3 I2C EEPROM Slave Address
Slave address is 1010000.
Note: 10-bit addressing is NOT supported.
5.2.2 In-Circuit EEPROM Programming
The EEPROM can be programmed via ATE by pulling RESET_N low (which tri-states the Hub’s
EEPROM interface and allows an external source to program the EEPROM).
5.2.3 EEPROM DATA
Table 5.1 User-Defined Descriptor Data
FIELD
BYTE
MSB:
LSB
SIZE
(BYTES)
DEFAULT
CFG
SELF
(HEX)
DEFAULT
CFG
BUS
(HEX) DESCRIPTION
VID 1:0 2 0424 0424 Vendor ID (assigned by USB-IF).
PID 3:2 2 2503 2503 Product ID (assigned by Manufacturer).
DID 5:4 2 0000 0000 Device ID (assigned by Manufacturer).
Config Data
Byte 1 6 1 98 1C Configuration data byte #1 for Hub options.
Config Data
Byte 2 7 1 90 90 Configuration data byte #2 for Hub options.
Non
Removable
Device 8 1 00 00 Defines the ports that contain attached
devices (this is used only when Hub is part of
a compound device).
Port Disable
Self-Powered 9 1 00 00 Selects the ports that will be permanently
disabled
Port Disable
Bus-Powered A 1 00 00 Selects the ports that will be permanently
disabled
Max Power
Self-Powered B 1 01 01 Max Current for this configuration (expressed
in 2mA units).
Max Power
Bus-Powered C 1 64 64 Max Current for this configuration (expressed
in 2mA units).
Hub Controller
Max Current
Self-Powered D 1 01 01 Max Current (expressed in 2mA units).
Hub Controller
Max Current
Bus-Powered E 1 64 64 Max Current (expressed in 2mA units).
Power-On
Time F 1 32 32 Time until power is stable.