Samsung 610 - Manual (Page 47)

47
English
05
Other
Information
Issues Solutions and Explanations
Others
The cable/set top box remote control
does not turn the TV on or off, or adjust
the volume. • Program the Cable/Sat remote control to operate the TV. Refer to Cable/Sat user manual for
SAMSUNG TV code.
A “Mode Not Supported” message
appears. • Check the supported resolution of the TV and adjust the external device’s output resolution
accordingly. Refer to resolution settings in this manual.
Caption on TV menu is greyed out. • Caption can not be selected in the TV menu when connected via HDMI or Component.
• Caption must be activated on the external device.
There is a plastic smell from the TV. • This smell is normal and will dissipate over time.
TV Signal information is unavailable in
the Self Diagnosis Test menu. • This function is only available with digital channels from an Antenna / RF/Coax connection.
(P. 22)
TV is tilted to right or left side. • Remove the stand base from TV and reassemble it.
The Channel menu is grey out
(unavailable). • The Channel menu is only available when the TV source is selected.
Your settings are lost after 30 minutes
or every time TV is turned off. • If TV is in the Store Demo mode, it will reset audio and picture settings every 30 minutes.
Please change from Store Demo mode to Home Use mode in the Plug & Play procedure.
Press the
SOURCE button to select TV mode, go to MENU → Setup → Plug & Play →
ENTER E.
You have intermittent loss of audio or
video. • Check the cable connections and reconnect them.
• Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the cables
are flexible enough for long term use. mounting the TV to the wall, we recommend using cables
with 90 degree connectors.
The PIP menu is not available. • PIP functionality is only available when you are using a HDMI, PC or components source.
You see small particles when you look
closely at the edge of the frame of
the TV. • This is part of the product’s design and is not a defect.
POP (TV’s internal banner ad) appears
on the screen. • Select Home Use under Plug & Play mode.
For details, refer to Plug & Play (Initial Setup). (P. 7)
✎ This TFT LCD panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However,
there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the
product.
¦ Storage and Maintenance
✎
If you remove the attached sticker on the TV screen, clean the residues and then watch TV.
Do not spray water or a cleaning agent directly onto the
product. Any liquid that goes into the product may cause a
failure, fire, or electric shock.
Clean the product with a soft cloth dapped in a small
amount of water.
[LD610-ZA]BN68-03637A.indb 47 2011-03-02 �� 1:38:22