Stamina Products AeroPilates Premier 690 - Manual (Page 7)

7
ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please
call our toll-free number for assistance 1 (800) 375-7520 or e-mail us at :
[email protected]
STEP 1
Remove your AeroPilates Premier 690 from its packaging placing the product on its side, with the LOCKING
PIN(29) side upward. Remove the LOCKING PIN(29) and unfold the MAIN FRAME ASSEMBLY separating
the half that has the attached LOCKING PIN(29). When completed, the frame should be separated
approximately three feet at the end.
STEP 2
Attach the four RUBBER FEET(28) to the FRONT FRAME(1) and REAR FRAME(2) with ROUND HEAD
SCREWS(M5x0.8x25mm)(38). Attach the WHEELS(27) to the FRONT FRAME(1) with WASHERS(M8)(47)
and NYLOCK NUTS(M8x1.25)(42).
STEP 3
Unfold your AeroPilates Premier 690 to a flat position by moving the FRONT FRAME(1) away from the
platform end of the product in a clockwise position until fully extended.