Sherwood RD-6513 User Manual
Page 16
ENGLISH
17
• Each time these buttons are pressed, the tone mode is
selected as follows :
OFF : To listen to a program source without the tone
effect. ("DIR" indicator lights up.)
ON : To adjust the tone for your taste.
("DIR" indicator goes off.)
Note :
• When the EXTERNAL IN is selected as an input source,
the TONE cannot be set to ON.
• Each time these buttons are pressed, the tone is
selected as follows :
→ BASS ↔ TRBL (treble) ↔ TONE : ON ←
When the TONE is set to ON to adjust the tone
(bass and treble).
• The tone level can be adjusted within the range of -10 ~
+10 dB.
• In general, we recommend the bass and treble to be
adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage your
speakers.
• To complete tone adjustment, repeat the above steps 11
and 12.
• If the tone display disappears, start from the step 9 again.
11.
Press the CURSOR UP(▲)/DOWN(▼)
buttons to select the desired tone.
12.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to adjust the selected tone as desired.
10.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to select the desired tone mode.
Adjusting the tone (bass and treble)
9.
Enter the tone mode.
• The tone mode is displayed for several seconds.
↕
RD-6513(A) 2008.8.21 12:19 PM 페이지 17