SECO-LARM USA Enforcer Relay Module SR-2224-C5 - Manual

®
● Switch selectable (see chart below) DC voltage output.
● Regulated and filtered output voltage.
● Switches to backup battery automatically in case of power loss.
● Short circuit protection.
● Built-in backup battery charger.
Four Models to Choose From
Model #
ST-1206-1.5A
ST-2406-2A
ST-2406-3A
ST-2406-5A
Voltage (DC) Current Current (peak)
6,12
6,12,24
6,12,24
6,12,24
1.5A
1.5A
2.5A
4.0A
2.0A
2.0A
3.0A
5.0A
● Triggered by positive voltage (+DC), closure of dry contact, or
opening of dry contact.
● Set from 1 sec. to 60 min.
● Relay programmable to activate at start or end of timing cycle.
● Relay programmable for pulse (flash) activation.
● Built-in reset function.
● Form-C relay, contacts rated 8A @ 120VAC/24VDC.
● LED indicator.
● 12/24VDC (auto sensing).
● Low current drain.
● 2 7 /
8
" x 2 1 /
2
" (73 x 63 mm).
SA-025
Power input
Current drain
Relay type
Contact ratings
12/24VDC (auto sensing).
Low
Form-C relay
8A @ 120VAC/24VDC.
Model Number:
Relay type:
Relay contact ratings:
Supply Voltage:
Current draw:
Programmable 6/12/24VDC,
default at 12VDC
70mA @ 12-24VDC
100mA @ 6VDC
SR-2224-C5
ENFORCER
Relay Module
Specifications:
Tel: 1-800-662-0800 (Domestic U.S. & Canada) Tel: 1-949-261-2999 (California & international)
Fax: 1-949-261-7326 Email: [email protected] Website: www.seco-larm.com SECO-LARM ® U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
RelayModuleb.p65
SR-2224-C5
DPDT, Form-C dry contacts
5A @ 250VAC/30VDC
® ENFORCER
Power Supplies
® ENFORCER
Timer Modules
Red LED - lights to show
relay is energized 2 Jumpers to
program
input voltage
(6,12,24V)
Input terminals to energize relay
Connection Diagram
Two separate sets of Form-C contacts
6V 12V 24V
JP1 ON ON OFF
JP2 ON OFF OFF
Preset 12V
+/- 20% of operating voltage
2.76" x 1.89" x .79"
(70 x 48 x 20mm)
1.94 oz. (55 g)
Foam tape (included)
Minimum pull voltage
Size
Weight
Mounting method:
Features:
•••••
Two separate sets of Form-C dry contacts.
•••••
Perfect for a variety of general switching purposes.
•••••
Can be connected for load switching, dry contact, latching
output, reverse polarity, line seizure, and other uses.
•••••
6/12/24 VDC operation, programmable by on-board
jumpers.
•••••
Red LED indicates relay is energized.
•••••
Large terminal blocks for easy installation.
•••••
Small size, easily fits inside alarm panel enclosures
or other hidden areas.
•••••
Foam mounting tape included.