beautypg.com

Emergency stop, Changing sanding belts, Notice – Woodstock W1751 User Manual

Page 22

background image

-20-

W1751 25" Wide-Belt Sander

O

PE

R

AT

IO

N

S

Emergency Stop

When pushed, the emergency stop panel shown in

Figure 16 stops the electricity to the motors and

also applies an air-disc brake to stop the sander

immediately.

To use the emergency stop, do these steps:

1. Push the bottom of the emergency stop panel.

2. Hold the emergency stop panel until the sander has

come to a complete stop.

Figure 16. Emergency stop panel.

KEEP the sanding drum drive belts correctly adjusted.

Otherwise, the sanding drum pulley will slip when

the emergency brake is applied and not immediately

stop the machine in the event of an emergency!

Emergency

Stop Panel

Changing Sanding Belts

When selecting sanding belt grit, keep in mind that the

Model W1751 accepts only 26" wide x 48" long sanding

belts. Consider the type of work, the species of wood,

and the quality of finish when selecting sandpaper. Use

these grit numbers shown in

Figure 15 as a general

guide to sandpaper type.

Sanding belts are often slightly different in shape and

tracking properties will be different for each belt.

Refer

to the

Jet Airflow, Belt Tracking and Belt Oscillation

procedures starting on

Page 23 so you can learn how to

quickly reset belt tracking and oscillation.

Note: For best results, do not increase

grit numbers more than 50 on any

successive pass.

• 60 Grit or less ................... Coarse

• 80-100 Grit ...................... Medium

• 120-150 Grit ..................... Fine

• 220 or higher ...... Not Recommended

Sandpaper will load up and burn.

Figure 15. General sandpaper types.

If you must use the emergency stop panel to stop

the sander, you may hear the belts squeal, and smell

a burnt rubber odor coming from the right side of

the sander. The noise and smell is a normal result

because the brake aggressively stops the sander.

Only use the emergency push panel to stop the

sander in an emergency situation. Do not use it for

normal shutdown. If you do, you will wear out the

belts, brake pads, caliper, and rotor very quickly.

NOTICE