Sirius Satellite Radio S50 - Manual (Page 16)

[
Getting Started
] [
Getting Started
]
Console Side mount method (b)
To mount the car dock using the console side mount method, assemble the mount as follows,
as shown in Figure 4:
Attach the adhesive foot to the extension arm, placing a collar in the arm before screw-
ing the foot to the arm. The side of the collar with the hole should face the foot.
Attaching the mounting bracket to the extension arm, placing a collar into the arm before
screwing the bracket to the arm. The side of the collar with the hole should face the
bracket.
Attach the car dock to the mounting bracket using the provided screws.
Before adhering the mount to the side of the console, be sure to select your mounting
position carefully because once the mount has been adhered to a surface, it will not be
possible to remove it and adhere it again.
Clean the selected mounting surface area in the vehicle with the alcohol swab.
Unscrew the adhesive foot from the mount. Peel the protective material off the adhesive
on the foot and press the foot firmly against the vehicle surface.
The adhesive mount should then be allowed to adhere for a minimum of 2-4 hours before
use. Best adhesion occurs after 24 hours. When the adhesive foot has achieved suf-
ficient adhesion, reattach the remainder of the mount to the foot.
Note that the console side mount method should not be used for mounting to the dashboard
of the vehicle.
1.
2.
3.
4.
5.
6.
7.
Adhesive
Foot
Collar Collar
Extension
Arm
Mounting
Bracket
Vehicle
Dock
figure 4 figure 4