Sony UWP Series User Manual
Page 11
Bodypack Transmitter
Handheld Microphone
Plug-on Transmitter
Oscillator
Crystal-controlled PLL synthesiser
Type of emission
F3E
Carrier frequencies
798 MHz to 822 MHz (TV channels 62 to 64) or 838 MHz to 862 MHz (TV channels 67 to 69)
Users may choose from 189 frequencies on each model.
RF power output
30 mW or 5 mW (selectable)
30 mW or 5 mW (selectable)
50 mW
Antenna
1/4
λ wave length wire
1/4
λ wave length wire (internal)
Integral type
Pilot tone signal
32 kHz
Frequency response
50 Hz to 18 kHz (typical)
100 Hz to 18 kHz (typical)
50 Hz to 18 kHz (typical)
Reference deviation
±5 kHz (-60 dBV, 1kHz input)
±5 kHz (94 dB SPL, 1kHz input)
±10 kHz (-60 dBV, 1kHz input)
Signal-to-noise ratio
60 dB or more (±5 kHz deviation at 1 kHz modulation, A-weighted)
60 dB or more (±10 kHz deviation at
1 kHz modulation, A-weighted)
Microphone capsule
—
Dynamic capsule (uni-directional)
—
Audio attenuator adjustment range
0 to 21 dB (in 3 dB steps)
Audio input level
-60 dBV (at 0 dB attenuator level)
—
MIC input position: -60 dBV (at 0 dB
attenuator level), LINE input position: +4 dBu
Audio input connector
3.5 mm (5/32 inch) dia., 3-pole mini jack
—
XLR-3-11C type
Max. input sound pressure level
—
151 dB SPL (at 21 dB attenuator level)
—
Indicators
LCD
Operating channel number/frequency, attenuator level, RF-output level (High/Low), audio input status
Operating channel number/frequency, attenuator-
transmitter battery status and accumulated operating time
level, audio input status, RF-output status,
transmitter battery status and accumulated
operating time
LED
Power status
Audio-input status
Power requirements
DC 3.0 V (with two AA-size alkaline (LR6) batteries)
Battery life
Approx. 6 hours with Sony AA-size alkaline (LR6) batteries at 25 °C (77 °F) at 30 mW output
Approx. 6 hours with Sony AA-size alkaline
(LR6) batteries at 25 °C (77 °F) at 50 mW output
Dimensions (W x H x D)
63 x 100 x 27 mm (2 1/2 x 4 x 1 1/8 inches)
φ52 x 240 mm (φ21/8 x 9 1/2 inches)
44 x 99 x 36 mm (1 3/4 x 4 x 1 7/16 inches)
Mass
Approx. 140 g (4.9 oz) including batteries
Approx. 300 g (10.6 oz) including batteries
Approx. 185 g (6.5 oz) including batteries
Supplied accessories
Omni-directional (UWP-C1)/Uni-directional
Microphone holder (x1)
Soft case (x1)
(UWP-S1/X1)lavalier microphone (x1),windscreen (x1),
microphone-holder clip (x1), belt clip (x1)
Portable Tuner
Half 19-Inch Rack-Size Tuner
Tuner Module
Oscillator
Crystal-controlled PLL synthesizer
Type of reception
Space diversity
Receiving frequencies
798 MHz to 822 MHz (TV channels 62 to 64) or 838 MHz to 862 MHz (TV channels 67 to 69)
Users may choose from 189 frequencies on each model.
Antenna
1/4
λ wave length wire
Pilot-tone signal
32 kHz
RF squelch level
15 dBµ
25 dBµ
Frequency response
50 Hz to 18 kHz (typical)
Reference deviation
±5 kHz (at 1kHz modulation)
Signal-to-noise ratio
60 dB or more (±5 kHz deviation at 1 kHz modulation, A-weighted)
Audio output connector
3.5 mm (5/32 inch) dia.,
1/4-inch phone jack (unbalanced)
–
3-pole mini jack (x1), unbalanced
or XLR-3-32 type (balanced)
Audio output level
-58 dBm
XLR-3-32: -28 dBm (LINE level) or -58 dBm (MIC level)
–
1/4-inch phone jack: -30 dBm
Monitor output connector
3.5 mm (5/32 inch) dia., stereo mini jack (x1)
1/4-inch stereo mini jack (x1)
–
Monitor output level
5 mW (at 16 Ω)
–
Indicators
LCD
Operating channel number/frequency, audio-output
Operating channel number/frequency, audio-output status, RF-input level
status, RF-input level, tuner battery status, and
accumulated operating time
LED
RF-input status
Power requirements
DC 3.0 V (two AA-size alkaline (LR6) batteries)
DC 9.0 V
Battery life
Approx. 6 hours (with Sony AA-size alkaline (LR6)
–
batteries at 25 °C (77 °F)
Dimensions (W x H x D)
63 x 100 x 30 mm
212 x 44 x 209 mm
56.6 x 25.5 x 121.0 mm
(2 1/2 x 4 x 1 3/16 inches)
(8 3/8 x 1 3/4 x 8 1/4 inches)
(2 1/2 x 1 1/16 x 4 7/8 inches)
Mass
Approx. 180 g (6 oz) including batteries
Approx. 1.3 kg (2 lb 14 oz)
Approx. 150 g (5.3 oz)
Supplied accessories
Microphone stand adaptor (x1)*, shoe-mount
AC/DC adaptor (x1)
–
adaptor (x1), belt clip (x1), output cable
(x2, 3-pole mini-plug/XLR-type, 3-pole
mini-plug/stereo mini-plug)
*Microphone stand adaptor is not included in the UWP-C3 package.
11
S P E C I F I C A T I O N S