Sears 33731 - Manual (Page 4)

InStAll thE lEFt SIdE BRACkEt
Remove the left Side hardware
Remove the following from the left side of the upper handle,
Figure 5. The hardware removed can be discarded.
Two 1/4-20 screws
Two flat washers
Two 1/4-20 cap lock nuts
1.
•
•
•
Figure 5
Install the left Bracket
Align holes in rod bracket [E] with holes in panel while placing end
of rod assembly [C] through the bracket. Secure with the following
items from the hardware pack, Figure 6:
Two 1/4-20 x 1.75” screws [F]
Four flat washers [H]
Two 1/4-20 cap lock nuts [G]
2.
•
•
•
Figure 6
ASSEMBlE thE GRASS BAG
Place grass bag [A] over chute assembly [B], Figure 7.
Use the cable tie [I] to secure bag to chute assembly by inserting
the cable tie into hole in bag and pulling through. Make sure cable
is positioned so it ties bag around indented groove (over flange)
of chute, Figure 7. Pull cable tight with pliers. 1.
2.
ASSEMBLY AND OPERATION
Figure 7
AttACh thE Rod hAnGER
Insert rod hanger [D] into the opening in the rod assembly [C],
Figure 8.
Slide the tabs on the grass bag over the bag hanger rod, Figure 8. 1.
2.
Figure 8
C
E
H
H G
F
B
A
I
D
C
Tabs