Seal-a-Meal VS125-S User Manual
Page 6
Replacement parts available at www.seal-a-meal.com or Call: 1-800-557-4825.
1. Open bag roll cover.
2. With a Phillips head screwdriver, unscrew the Replacement Blade door.
3. Remove the blade door.
4. Replace the old knife blade with the new one.
5. Replace the door.
6. Tightly secure the screw.
CAUTION: Sharp blade.
Seal
Vacuum
BATTERY REPLACEMENT AND RECYCLING INFORMATION
Replacement parts available at www.seal-a-meal.com or Call: 1-800-557-4825.
Should your Vacuum Food Sealer Battery need to be replaced, follow the steps below:
1. Place Sealer upside down on a clean, soft surface (such as a towel or cloth). This will protect
the finish from scratches.
2. Using a Phillips head screwdriver remove two captured screws located on Battery
Compartment Door.
3. Squeeze battery connector to release latch and remove.
-11-
REPLACING THE BAG CUTTER BLADE
1. Pull Lever forward to release Nozzle/Drip Tray.
2. Carefully remove as not to spill any contents.
3. Over sink, open rubber Drain Plug located under the tray at the far end (Do NOT remove the
recessed plug) and flush, or soak in warm soapy water (with a mild dish detergent).
4. Rinse thoroughly and allow to dry.
5. Replace Lock ‘n Seal™ Nozzle.
Cleaning the Bags
•
Wash bags in warm, soapy water.
•
Bags can be washed in the dishwasher if desired. Turn bags inside out and spread them over the top rack.
•
Allow bags to dry completely before using.
NOTE: DO NOT reuse bags if they have been used to store raw meats, fish, oily foods or have been
boiled or microwaved.
CARE AND CLEANING (CONT.)
Follow the steps below to wall mount your Seal-a-Meal
®
Vacuum Food Sealer. This is for storage only;
do not operate the Vacuum Food Sealer from the wall. Anchors and screws included.
1. Bore two 1/4” holes ( 12" apart) along a straight line on the wall, either vertically or horizontally.
2. Hammer one screw anchor into each hole.
3. Screw the provided screws into the anchors leaving 3/8” head outside of the wall.
4. Hang Sealer on the screw heads.
NOTE: Mounting is for storage only. Always clean the Removable Nozzle/Drip Tray prior to storing in
the wall mounted position. The Vacuum Food Sealer should not be used while mounted on the wall.
WALL MOUNTING FOR STORAGE
REFILLING THE BAG ROLL
1. Pull out one end of spring loaded bag roll holder.
2. Remove cardboard from empty roll.
3. Slide replacement roll onto holder. Make sure roll is positioned to dispense from the bottom.
4. Place end of holder back into slot.
-10-
VS125(428-1250) V.qxd 1/10/05 16:25 Page 11