Sanyo CLT2054 - Manual (Page 6)

6
Installing Batteries / Signal Connection: Cable, Antenna, or Satellite Receiver
Installing Batteries in the Remote Control
Use 2 “AAA” batteries (Not supplied).
Be sure batteries are installed correctly.
Note: Do not mix old batteries with new ones
or mix different types of batteries together.
Getting Started
Connecting Cable service, RF antenna, or Satellite Receiver to the TV
3 4
R-AUDIO-L
R-AUDIO-L VIDEO
VIDEO
VHF/UHF
TO TV
FROM ANT.
RF CHANNEL
IN
OUT OUT
IN
YPbPr RGB
DIGITAL AUDIO OUT
COAXIAL
COMPONENT OUT
(1080i/720p/480p)
(1080i/720/480p)
Y
P B
P R
A/V OUT (480i)
S-VIDEO OUT AUDIO
L
R
VIDEO
RGB OUT
AUTHORIZED SERVICE ONLY
ANT LOOP OUT
ANT IN
OUTPUT SELECTION
DIGITAL AUDIO OUT (OPTICAL)
L
(MONO)
L
(MONO)
S-VIDEO
AV2 AV1
AV3
TUNER
DC IN
V V
R R
R
L
VHF
UHF
CATV
Y
Pb
Pr
POWER
(DC IN 19V)
TV–75 OHM
CONNECTOR
Note: If you do not have
a VCR, connect signal
directly to the TV 75 ohm
jack.
CATV FRANCHISE NOTE: Cable companies, like public utilities, are franchised by local government authorities. To receive cable programs,
even with equipment which is capable of receiving cable channels, the consumer must subscribe to the cable company’s service.
QuickTips
■ The TV will automati-
cally select the correct
Antenna mode for the
type of RF signal you
connect.
■ TV will switch off
automatically after 15
minutes if there is no
signal reception (cable
out or station not
broadcasting).
Exception—When
the Video mode is
selected, the TV will
not automatically
switch off when signal
reception has stopped
for 15 minutes.
■ If you move the TV to
a new location, press
the RESET key twice
after connecting the
signal and turning on
the TV.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
Operational Tip for No Signal Connection:
If the TV is used as a monitor only, with a DVD player or some other type of external equipment, and no cable or
antenna signal is available, the following setup is necessary:
Your TV is designed to automatically search for available channels. Therefore, the initial start up requires that you press
the MENU key, enabling the TV to automatically go through the channel search process before you can operate the
TV. After the initial channel search is completed, you must press the MENU key again to complete the channel search
process, it will take a few minutes for the TV to complete searching.
After channel search is complete (2 searches), you can press the INPUT key on the remote control to use the TV as a
monitor.
TV BACK
RF ANTENNA CABLE SATELLITE RECEIVER
VCR