Sanus Systems PFFP2 - Manual (Page 6)

Step 7: Mounting Monitor Brackets to a television with a flat back
First, determine the diameter of the Bolt (y,z,aa,bb) your TV requires by hand threading them into the threaded insert on the back of
the TV. If you encounter any resistance stop immediately! Once you have determined the correct diameter, see the appropriate Diagram
below. You will thread the Bolt through the appropriate Lock Washer (gg,hh,ii,jj), a Washer (kk,ll), the Monitor Bracket (e,f), and finally
into the TV. Make sure the Monitor Brackets are vertically centered and level with each other. See the appropriate Diagram below.
Note: For televisions with a curved back, or an obstruction near the threaded insert see Step 8.
M4 Diameter Bolt M6 Diameter Bolt
f e
y aa
gg ii
kk ll
Diagram 7
M5 Diameter Bolt M8 Diameter Bolt
f e
z bb
hh jj
kk ll