Sega 999-1108 - Manual (Page 74)

67
13. REPLACING THE FLUORESCENT LAMP, AND LAMPS
FIG. 13 a
FIG. 13 b
Remove the billboard holder, slide up the billboard plate, and replace the fluorescent tube.
When performing work, be sure to turn power off. Working with power on
can cause electric shock and short circuit hazards.
The Fluorescent Lamp, when it gets hot, can cause burn. Be very careful
when replacing the Fluorescent Lamp.
Be sure to use lamps of the designated rating. Using lamps of undesignated
rating can cause a fire or malfunctioning.
To perform work safely and securely, be sure to prepare a step which is in a
secure and stable condition. Performing work without using the step can
cause violent falling down accidents.
Be careful when handling the plastic made parts. Failure to observe this may
cause injury due to damage or fragments resulting from damage.
INSIDE THE BILLBOARD
When performing work,
prepare a step.
TRUSS SCREW (3) black
M4 X 8
BILLBOARD HOLDER
BILLBOARD PLATE
FLUORESCENT LAMP 32W:390-5251-32-01
GLOW LAMP:390-5638-5P
To slide.